Step 4

Ok, time to test what you just soldered. First use the continuity check on a multimeter to make sure the wires aren't shorting to ground or to each other. Make sure your switch is in the off position. Power up your iPhone. Hopefully it didn't smoke :) Now go into minicom to tty.baseband and send a few commands, AT a few times will do. It should respond OK. Now flip your switch, the baseband should stop responding. Even when you flip it back, the baseband still shouldn't respond. Be sure your switch is off, then open another ssh and run "bbupdater -v" You can get bbupdater off the ramdisk. This should reset the baseband, and minicom should start working again. If it did this, your soldering is most likely good, and you are ready to actually start unlocking your phone!!!